Pickering Winery SupplyOther products     About us     Contact
TANKS OAK CORKS CAPSULES CHEMICALS COATINGS
The information in this data sheet is to the best of our knowledge correct at the date of printing. The company reserves the right to modify data without notice. Any change in data will normally be followed by issue of a new data sheet. The user should check the date of printing and if more than 12 months have elapsed, then the data should only be used after checking with our nearest sales office to establish that they are still valid. Since condition of application and service may be beyond our control, no liability can be accepted on the basis of these data. Dated 10/9/00
PRODUCT DESCRIPTION: RE-84 is a specially formulated acrylic emulsion and additive that combine to transform rust into a black acrylic plastic protective paint film. It actually converts the rust on the surface to an integral part of the newly created, rust inhibiting finish. You can watch the change take place in about 15 to 20 minutes.
RECOMMENDED USES:For use on all rusted iron and steel surfaces in wineries and around vineyards. Not recommended for galvanized metals unless old and rusted.
SURFACE PREPARATION:The rusted surface must be dry and free from residue, oil, grease or wax. Remove loose scale. It is not necessary to sand the remaining rust
APPLICATION:Shake contents. IMPORTANT: To avoid contamination, do not work out of this container. Pour the amount needed for the job into a separate plastic, glass or paper container. Do not return used material to the original container.

Apply a liberal first coat to the rusted area with a paint brush, roller or airless spray. DO NOT THIN. Allow to dry (15 to 20 minutes), apply a second coat Do not apply to a hot surface or at temperatures less than 50°F . If top coating is desired, allow to dry 24 hours and paint with an oil based enamel recommended for metal surfaces.
COVERAGE:Varies with the rusted surface being coated. Approximately 600 square feet per gallon.
DRYING TIME:15 to 20 minutes at 70°F and 70% humidity. Allow 24 hours before painting.
CLEAN UP:Soap and warm water.
CAUTION:Keep out of reach of children. Do not take internally. If taken internally, consult a physician. When spraying, a protective mask should be worn to avoid inhalation. Eye Irritant! In the event of eye contact, flush eyes with water for 15 minutes and promptly seek medical attention.